TRAINING

For interior use, the preparation of walls must be made in accordance with the building codes for the preparation of walls for painting. Minor defects and scratches are not allowed. We draw your attention to the fact that the pronounced curvature of the walls and frequent deep defects will have a significant impact on the consumption of decorative material in a big way.

After priming the walls with a special reinforcing impregnation of deep penetration PRIMER NORMAL (after 4-6 hours), you can start applying the very decor MARMORINO CARRARA.

DECOR

The first layer should be applied with a thickness of 1-2 mm., Leaving nodules that form boundaries resembling the veins of natural stone. It is this method that will subsequently work as the basis for imitation of the veins of natural marble, therefore we recommend that you treat their projection with taste. Drying time of the first layer: 4-8 hours, then you can proceed to the second layer. Before applying the second layer, we recommend lightly (it is necessary to preserve the created nodules and streaks) to sand the surface using emery paper such as K1500, in order to eliminate the light defects formed during the application of the first coating layer.

If you want to intensify the veining effect in a light direction, then you do not need to tint the first layer of decorative plaster MARMORINO CARRARA (use just the base - white), and if you want to make the streaks brighter, then the material MARMORINO CARRARA for this (first) layer, It should be zakolerovat in a richer than the main - your chosen color. For advice and assistance in tinting, we recommend contacting our authorized representatives or our company. We will be happy to help you!

The second and third layers are applied using the classic Venetian method, using a trowel with rounded corners in stainless steel. The material should be applied thinly (almost on the sheet), covering the entire surface. The second layer is not polished if there are subsequent ones, since it is necessary to preserve adhesion (adhesion) with subsequent coating. Only finish should be polished (last layer). Polishing is performed with the same tool (Venetian trowel), after 10-15 minutes. Since the material is mineral, therefore, with a strong pressure on the trowel during polishing, the material may be ironic, which will affect the decorated surface in the form of gray veins or spots. We recommend polishing without pressure and not to a perfectly glossy effect, since this technique is aimed at the manifestation of the previous layers,

Before applying a wax protective coating SPECCHIO CERA, the finished decorative coating should be completely dry - at least 24 hours. The wax is applied with the same tool (Venetian trowel), a thin layer, covering the entire surface. The technique of applying wax is identical to the technique of applying finishing layers of Venetian plaster. After application, the wax should dry and the walls will become completely dull. Waxing time: 4-8 hours. Then, using natural wool or special wool mittens, in a circular motion, without much pressure on the surface, polish the entire surface to a glossy effect. If you decorate walls in rooms with high operational loads or with high humidity (bathroom, basement or pool), we recommend re-applying a wax coating after 24 hours,

Full drying time of the decorative coating: 24 hours.

For more detailed advice or a master class on application, we recommend contacting our technical experts or using the services of our stores.

We pay your attention that the decorated walls should stand not less than 24 days, before their primary cleaning.

As a substrate, you can apply a RUVIDO quartz base, pre-diluted with water to 50%. In this case, the substrate will increase the degree of adhesion of the walls and reduce the consumption of decorative material Marmorino Carrara when applied. To protect against moisture, the finished coating must be applied wax protection type SPECCHIO CERA.